Trane DC-UC-WEB01 Heat Pump User Manual


  Open as PDF
of 7
 
5 DC-UC-WEB01
GAS VALVE
ORIFICE
BURNER
MANIFOLD
MANUAL
ON/OFF
SWITCH
Regular Service Maintenance
Cooling and Heating Season
Basic Maintenance – For All Packaged Systems
To keep your unit operating safely and efficiently, a qualified
service technician should check the entire system seasonally,
and any other time that you feel a check is needed. Your service
technician may examine these areas of the unit:
1. Filters(forpossiblecleaning)
2. Motors(condenserandevaporatormotorsare
permanentlylubricated)
3. Gaskets(forpossiblereplacement)
4. Refrigerantcoils(forpossiblecleaning)
5. Safetycontrols(formechanicalcleaning)
6. Electricalcomponentsandwiring(forpossible
replacementandconnectiontightness)
7. Condensatedrain(forpossiblecleaning)
8. Inspecttheunitductconnectionstoseethattheyare
physicallysoundandsealedtotheunitcasing.
9. Inspecttheunitmountingsupporttoseethatitissound.
10.Inspecttheunittoseethatthereisnoobviousunit
deterioration.
Heating Season Additional Maintenance – For
Gas/Electric and Dual Fuel Packaged Systems
At the beginning of each heating season arrange for a qualified
service technician to complete the unit inspections and service
routines described in this section.
These steps should be performed ONLY by a qualified service
technician.
1. Inspectthecontrolpanelwiringandheatingcontrolstomake
sureconnectionsaretightandwiringinsulationisintact.
2. Checktheoperationofthegasignitionsystem.
a.Turntheunitonandoffatthethermostattobesure
theignitioncontrolandsparkelectrodeareoperating.
b.Turnoffthegassupplywiththeunitoperatingto
verifythatthegasvalveclosesandthatare-ignition
cycleisinitiatedbytheignitioncontrol.
3. Checktheburnermanifoldpressure.Apressuretapis
providedinthegasvalveforthispurpose.
4. Visuallyinspectalloftheunit'sueproductpassageways
forexcessivedepositbuilduporcorrosion.Ifbuildupor
corrosionisapparent,performthenecessaryrepairs.
 5. Visuallycheckthemainburnerames.Theyshouldbebright
blueamesextendinguptotheheatexchangersections.
ELECTRIC SHOCK HAZARD
To prevent injury or death due to electrical shock or contact
with moving parts. Lock unit disconnect switch in open
position before servicing unit.
HAZARDOUS GASSES
Exposure to fuel substances, or by-products of incomplete fuel
combustion, is believed by the state of California to cause cancer,
birth defects, or other reproductive harm.
This warning complies with State of California law, Proposition 65.
This product must be gas piped by a Licensed Plumber or Gas
Fitter in the Commonwealth of Massachusetts.
ELECTRIC SHOCK HAZARD
Should overheating occur, or the gas supply fail to shut off, shut
off the manual gas valve to the furnace before shutting off the
electrical supply.
In the event that electrical, fuel or mechanical failures occur, the
owner should immediately turn off the gas supply at the manual
gas valve located in the burner compartment and electrical
power to the furnace and contact service technician.
GASVALVE
ManualOn/OffSwitch
Figure 2. Gas Valve with On/Off "Toggle" Switch
IMPORTANT: Some of these products have been designed
and manufactured to meet ENERGY STAR criteria for energy
efficiency. However, proper refrigerant charge and proper
air flow are critical to achieve rated capacity and efficiency.
Installation of this product should follow the manufacturer’s
refrigerant charging and air flow instructions. Failure to confirm
proper charge and airflow may reduce energy efficiency and
shorten equipment life.
For regular dealer maintenance please refer to
www.acca.org/industry/quality
 previous next