Filter
Top Products
32-5035-02 4
User’s Information
not remove the door until all lights are off.
♦ Disconnect the power cable, if required,
and place the door in a secure location.
♦ Rotate the two latches and remove the
door.
PRE-FILTER CLEANING:
The pre-filter can be vacuumed
(recommended) or washed clean.
It is recommended the filter be vacuumed
outside the home to ensure particles on the
filter are not re-introduced into the air.
Persons highly sensitive to the collected
particles should wear appropriate respiratory
protection while cleaning the filter.
The pre-filter can be washed using low
pressure water spray, such as a sink sprayer
or garden hose. The pre-filter should be
completely dry before re-installing. Re-install
the pre-filter noting the airflow direction as
indicated on the filter.
NOTE: Do not replace the plastic pre-filter
with a metal type pre-filter. A metal pre-filter
will cause reduction in efficiency and
potential failure of the system electronics.
COLLECTION CELL CLEANING
Remove both collection cells from the system
housing. The cells can be cleaned either by
vacuuming (recommended method) or by
washing.
VACUUM CLEANING
Using the wand attachment, vacuum both
sides of the collection cells until they are clean
It is recommended the filter be vacuumed
outside the home to ensure particles on the
filter are not re-introduced into the air.
Persons highly sensitive to the collected
particles should wear appropriate respiratory
protection while cleaning the filter.
WASHING
Use low-pressure water spray, such as a sink
sprayer or garden hose to clean the cells.
Stubborn residue like tobacco smoke may
require warm water to be removed.
Do NOT use soap or detergent in cleaning the
collection cells.
Do NOT immerse the cells completely in
water.
Do NOT place the cells into a dishwasher to
clean.
Slightly tap the collection cells to remove
water retained in the filter. Allow the collection
cells to dry completely before re-installing.
Re-install the collection cells. With the handles
facing the front of the unit, align the slot on the
cell with the tab on the cabinet. Fold the
collection cell handles flat once installation is
complete.
RE-INSTALLING THE POWER
DOOR
Install the door by positioning tabs inside of the
frame and rotating the door into place. Rotate
the two latches to secure the door. Plug in the
power cable if removed. Turn on power to the
unit by pressing and releasing the power
button.
NOTE: The first green LED will be on but will
not flash for the first 10 minutes the indoor fan
is operating. This is a drying cycle for the pre-
filter and collection cells.
RESET THE FILTER TIMERS
To reset the pre-filter timer, press and hold the
RESET button until the pre-filter LED turns off.
(1 to 2 seconds)
To reset the collection cell timer, press and
continue to hold the RESET button until the
collection cell LED’s turn off. (4 to 5 seconds)