Filter
Top Products
– 142 –
[In case of sucking system from rear side]
[In case of sucking system from rear side]
[In case of sucking system from bottom side]
[In case of sucking system from bottom side]
Air filter
Air filter
Air filter
Air filter
Hook
Hook
Hook
Hook
Push
Push
Push
Push
Plate inlet-A: 8 screws
Plate inlet-A: 8 screws
Plate inlet-B: 6 screws
Plate inlet-B: 6 screws
Plate inlet-A: 11 screws
Plate inlet-A: 11 screws
Plate inlet-B: 6 screws
Plate inlet-B: 6 screws
Air filter
Air filter
Hook
Hook
Push
Push
Plate inlet-A: 8 screws
Plate inlet-B: 6 screws
Plate inlet-A: 11 screws
Plate inlet-B: 6 screws
No.
1
2
Part name
Air Filter
Plate inlet-A
Plate inlet-B
Procedure
1. Detachment
1) Push knobs (3 positions) of the air filter hooks
toward the arrow direction to remove the air
filter.
2. Attachment
1) Insert the air filter surely into the hooking
grooves (4 positions) at the opposite side of the
hooks, and then fix it to the original position.
NOTE)
In case of sucking system from bottom side,
installation direction is determined. Install the air
filter so that hooks are aligned at discharge side.
1. Detachment
1) Take off fixing screws while holding the plate
inlet-A with hands to remove it.
(Sucking system from rear side: Ø4 × 10, 8 pcs)
(Sucking system from bottom side:
Ø4 × 10, 11 pcs)
2) Take off fixing screws while holding the plate
inlet-B with hands to remove it.
(Ø4 × 10, 6 pcs)
NOTE)
Be careful that sheeting metal does not fall when
removing the plate inlet.
2. Attachment
1) Using the screws taken off in procedure 1. 2) of
2
, attach the plate inlets in order of B
→ A while holding them not to fall down.
Remarks
14. DETACHMENTS
14-1. Indoor Unit
14-1-1. Slim Duct Type
RAV-SM404SDT-E, RAV-SM454SDT-E, RAV-SM564SDT-E
REQUIREMENT
Be sure to put on gloves at working; otherwise an injury may be caused by parts, etc.
• Before replacement of the parts, be sure to stop operation of the air conditioner and turn off
switch of the breaker.