Filter
Top Products
–6–
Under Ceiling Type
Installation Manual
EN
Toshiba
Wireless remote control
Decide the position which remote control is operated
and the installation place.
And then refer to the Installation Manual of the wireless
remote controller kit sold separately.
(The signal of the wireless type remote control can be
received within approx. 23’ (7 m). This distance is a
criterion and varies a little according to capacity of the
battery, etc.)
• To prevent malfunction, select a place where is not
affected by a fluorescent lamp or direct sunlight.
• Two or more (up to 6 units) wireless-type indoor units
can be set in a room.
Before installation
1 Removal of suction grille
Slide the suction grille fixing knobs (2 positions)
toward the arrow direction, and then open the
suction grille.
Under the condition of suction grille opened, push
the hook section of hinges (2 positions) at the rear
side, and then pull out the suction grille.
2 Removing wire guard
Remove the screws (2 pcs.) which are fixing the
wire guard.
Remove the clamp fixing screws and remove the
wire guard.
CAUTION
Attach back the wire guard once indoor unit is installed.
Remove the 2 screws fixing the wire guard and hung the
wire guard with the clamps during a service.
A
p
p
r
o
x
.
2
3
’
(
7
m
)
Pull out suction grille
while pushing hook.
Suction grille
fixing knob
Suction grille
Hinge
S
l
i
d
e
Clamps
Screw
Wire guard
6-EN
+00EH99864801_00Ta.book Page 6 Tuesday, November 24, 2009 5:40 PM