Filter
Top Products
– 100 –
Suction grille
Pull out suction grille
while pushing hook.
Suction grille
fixing knob
Hinge
Slide
Slide forward.
Side panel
Level flap
Protector
3 -2
3 -3
3 -4
3 -5
Screws
(Fixing electrical parts cover and box)
Electrical parts cover
Screws
(Fixing electrical parts box and main unit)
Electrical parts box
Electrical parts box
10-3. Ceiling Type
RAV-SM
∗∗∗∗∗∗
∗∗∗∗∗∗
∗∗∗
CT
∗∗
∗∗
∗
Be sure to turn off the power supply or circuit breaker before disassembling work
No.
Part name
Suction grille
Side panel
Electrical
parts box
Procedure
1. Remove the screws of air intake
grille fixing knob on a side of each
filter.
2. Slide the suction grille fixing knobs
(2 positions) toward the arrow
direction of left figure, and open
the suction grille.
3. Under the condition of the suction
grille opened, push the hook
section of hinges (2 positions) at
the rear side, and then pull out the
suction grille.
1. Open the suction grille.
2. After removing the side panel
screws (2 positions), slide the side
panel forward and then remove it.
1. Remove the suction grille.
2. Loosen the set screws
(2 positions) of the electrical parts
cover.
3. Remove the electrical parts cover.
4. Remove the set screws
(2 positions) of the electrical parts
box.
5. Remove the electrical parts box.
In this time, remove connectors of TA
sensor, TC sensor and TCJ sensor if
necessary.
Remarks