Filter
Top Products
1. Switch off the main power switch and disconnect the power cord from the power source.
2. Open the PSU box [A].
To set the connector
1. Connect the white connector [B] to CN602 on the AC drive board [C].
NOTE:
Connect the large connector clamped beneath the board.
This step is not required if the LCIT anti-condensation heater will be connected.
To supply power 24 hours a day
Doing the connection in the previous procedure assures that power is supplied to the machine
for the heaters even after the main machine is switched off with the main power switch (for
example, in auto off mode). However, with only this connection, the heaters do not operate
while the main machine is operating.
Another connection can be done so the heaters in the paper tray unit will stay on continuously.
The ‘24 hours a day’ connection applies only to the tray heaters, not the transfer and
scanner units.