Toro 5800 Fan User Manual


  Open as PDF
of 2
 
Multi Pro
®
5800 Pro Control
TM
XP Key Reference
BOOM 1
CAL
1
BOOM 2
CAL
2
BOOM 3
CAL
3
SPEED
CAL
4
METER
CAL
5
VALVE
CAL
6
RATE 1
CAL
7
RATE 2
CAL
8
VOL
TANK
9
TIME
0
SELF
TEST
CE
TOTAL
AREA
TOTAL
VOLUME
FIELD
AREA
FIELD
VOLUME
VOL/
MIN
AREA /
HOUR
DATA
MENU
DISTANCE SPEED ENTER
DATA ENTRY KEYSTROKE SEQUENCE:
1. Depress the key in which you wish to enter data (i.e. “BOOM 1 CAL”, “SPEED CAL”, etc.) and then Depress .
2. Depress the keys corresponding to the number you wish to enter (i.e. “2”, “4”, etc.) and then Depress to complete the entry.
ENTER
ENTER
*Numbers listed are default system values. Before spraying, calibrate your sprayer to confirm the numbers used are correct. Consult the Pro Control XP Operator’s Manual for full details on Set-Up and Operation.
* Use 80” [203 cm]
Number of nozzles
x spacing in inches [cm]
of left boom.
* Use 60” [152 cm]
Number of nozzles
x spacing in inches [cm]
of center boom.
* Use 80” [203 cm]
Number of nozzles
x spacing in inches [cm]
of right boom.
*
Use 148 [38] w/Half Full
Tank. Reset Distance readout
to “0”. Drive vehicle 500 ft.
Verify distance readout is
490-510 ft. [150 m]
Use number on silver tag
on the Flow Meter’s cable.
* Use 23 (for 0.5 GPM &
higher nozzles).
Use 46 (for 0.2 & 0.4
GPM nozzles).
Sets system response.
First rate of application
in Gal/Acre. Gal/1000 sq.
ft., or lit/ha depending on
initial set up.
Second rate. If only one
rate is used, use same
value here that was used
in Rate 1.
Reset volume when filling.
24-Hour Clock (military
time) or Elapsed Timer.
Simulates speed to allow
operator to check system
operation before applying
chemicals while vehicle is
parked. If “SELF TEST” is
depressed and held at any
time, US, TU or SI will flash,
indicating spray area en-
tered during initial setup.
Clear entry – Will clear a
wrong entry. Also used
in Initial Programming to
toggle between settings.
Totals area covered in
acres, 1000 sq. ft. or ltr/ha
until cleared to zero.
Monitors volume applied
in gallons or liters until
cleared to zero.
Totals area covered in
acres, 1000 sq. ft. or ltr/ha
until cleared to zero.
Monitors volume applied
in gallons or liters until
cleared to zero.
Measures distance in
feet or meters until
cleared to zero.
Displays speed in MPH
or km/h.
Displays gallons or liters
per minute that system
is currently using.
Displays acres, 1000 sq. ft.
or hectare covered per
hour at speed driven.
Used to adjust Agitation.
(Note: when the number
increases, the agitation
pressure increases.
This number is NOT the
agitation pressure.)
Used for other operations,
See Owner’s Manual.
Used to enter data into
Console.
11-082-T Part No. 120-8599
 previous