Filter
Top Products
ASSEMBLING THE STEAM VACUUM
7
Top Innovations, Inc.
CONNECTING / DISCONNECTING HOSE
1. Align connector end of Hose with Hose Connection Base as shown (FIGURE 1),
and insert it. Press in until two locking tabs on Hose snap through two holes
on sides of Hose Connection Base.
2. To remove Hose from Hose Connection Base, press in on two locking tabs and
firmly pull Hose out of Hose Connection Base.
USING THE STEAM VACUUM
10
Top Innovations, Inc.
OPERATING STEAM VACUUM
NOTE: Be sure that water reservoir and Water Filtration Chamber have
already been filled and that all desired accessories are connected before
following these steps.
1. Plug power cord into a convenient electrical outlet (make sure to first remove
plastic cover that protects plugs during shipping).
CAUTION: This unit uses a grounded (3-prong) electrical plug. Use only in
properly installed 3-prong electrical outlets. Do not attempt to alter plug or
circumvent this safety feature in any way.
2. Set Main Control Switch to desired mode (vacuum mode or steam mode)
(FIGURE 7).
VACUUM MODE
1. When set to vacuum mode, unit suction will begin automatically. You are
immediately ready to begin your vacuuming tasks.
2. While vacuuming, it is possible to alter the force of suction, by using switch on
top of Handle. Move it forward to increase suction power, and move it
backwards to decrease suction power. This is useful for when vacuuming rugs or
other materials on which you may not want to use maximum.
3. As you vacuum, it may become necessary to stop and empty Water Filtration
Chamber. Simply follow these steps:
- Unhook locks and remove Water Filtration Chamber cover,
- Remove Water Filtration Chamber (there are no locks holding it in place;
simply pull it out),
- Remove filter
- Empty Water Filtration Chamber into toilet (for dirty water) or trash can
- Replace filter and refill Water Filtration Chamber with water (10 oz.)
- Set Water Filtration Chamber back in place
- Replace Water Filtration Chamber cover and re-latch locks
NOTE: It is recommended that you remove and clean filter in Water Filtration
Chamber after several uses. Simply remove it and rinse thoroughly with warm
water, then replace it. After approximately 6 months of regular use, you may
wish to replace this filter to maintain optimum filtration. Refer to page 14 of this
manual for information on obtaining replacement filters.
CONNECTING ATTACHMENTS TO
VACUUM / STEAM NOZZLES
1. Slide Open/Close lock on Squeegee Head, Steam Jet Nozzle or Vacuum Head to
“Open” position.
2. Align Squeegee Head, Steam Jet Nozzle, Vacuum Head or Small Vacuum Head
with Vacuum/Steam Nozzles as shown (FIGURE 2), and press firmly onto
Vacuum/Steam Nozzles. Note that Small Vacuum Head only fits onto Vacuum
Nozzle, and does not have an Open/Close lock.
3. Slide Open/Close lock on Squeegee Head, Steam Jet Nozzle or Vacuum Head to
“Close” position.
FIGURE 1
FIGURE 2
FIGURE 7