Filter
Top Products
ATTACHING STEAM JET NOZZLE
1. Insert cylinder on back of Steam Jet Nozzle (FIGURE 1) into hole on face
of main unit (FIGURE 2). Insert it so that two tabs on sides of cylinder
(FIGURE 1-A) fit into two tab holes on sides of main hole (FIGURE 2-B).
A
SSEMBLY
I
NSTRUCTIONS
8
2. Rotate Steam Jet Nozzle in direction indicated by the “Lock” arrow at
rear of nozzle (counter-clockwise). Twist until it will move no further to
ensure it is properly and securely seated.
FIGURE 1 FIGURE 2
ATTACHING SMALL ACCESSORIES
1. To attach Scrub Pad (FIGURE 3-A), Angled Steam Nozzle (FIGURE 3-B),
or one of the three Utility Brushes (FIGURE 3-C), first make sure Steam Jet
Nozzle is properly installed. Then simply slide accessory onto end of
Steam Jet Nozzle as illustrated (FIGURE 4).
IMPORTANT: To avoid injury, slide utility brush all the way to end of
Steam Jet Nozzle as illustrated (FIGURE 4) to ensure no steam escapes.
FIGURE 3 FIGURE 4
To
p
Innovations
,
Inc.
WARNING: Do not try to connect attachments while unit is emitting steam.