Filter
Top Products
INSERTING/REMOVING FILTERS
Your ThunderVac utilizes three filters that work together to prevent dust
and
other particles from escaping the vacuum and re-entering the air.
1. ULTRA Filter –
traps over 92.4% of air impurities. Located inside
Cyclone Cup
2. Charcoal Filter – reduces odors during cleaning process. Located
behind Filter Assembly.
3. Exhaust Filter – located in rear compartment of unit.
INSERTING FILTERS
1. Place ULTRA Filter inside Cyclone
Cup. Slide over the end of smaller
cylinder inside Cyclone Cup
(FIGURE 1).
2. Place Charcoal Filter inside Filter
Disc, with softer side facing out.
Filter Disc then fits into the back of
Filter Assembly, with exposed side of
filter placed against Filter Assembly
(FIGURE 2).
3. Open Exhaust Filter Access Door
on back of main unit by pressing down
on top tab and pulling outwards. Place
filter into rectangular hole inside
compartment (with grated side of filter
facing out). Reattach Access Door
(FIGURE 3).
REMOVING FILTERS
To remove filters, simply reverse steps
listed above. This is useful for
cleaning filters or replacing them with
new ones. See Cleaning Filters
section on page 9 for more
information. DO NOT place a
recently cleaned filter back into the
unit until it is completely dry.
8
FIGURE 1
FIGURE 2
FIGURE 3
Top Innovations, Inc.