Filter
Top Products
SAFETY AUTO SHUT OFF
NOTE: If the Water Tank and the Water Basin is empty, the water droplet warning
symbol will illuminate on the LCD Display to signal the Water Tank should be
refilled. The current room humidity will be displayed, and the Humidifier will
automatically shut itself OFF.
If this happens, follow these Reset Instructions to re-start your Humidifier:
1. Unplug the unit. Remove and refill the Water Tank, replace the Tank into the
Humidifier Housing on the Water Basin.
2. Follow “Operating Instructions” outlined in this Owner’s Manual to
restart operation.
USING THE PROGRAMMABLE TIMER
The Cool Mist Humidifier can be programmed to run for a preset duration and then
automatically turn itself OFF after the set amount of time.
1. Press the TIMER Button to select run time of the unit. Each time the Button is
pressed, the Display will advance from 8hr, 4hr, 2hr or 1hr and then back to
CONTINUOUS RUN.
NOTE: The Cool Mist Humidifier holds 1.2 gallons of water and will run for
12 hours of continuous operation before refilling is necessary.
2. The clock symbol will flash for 5 seconds after the Timer selection is made.
The Timer program is now set for the selected duration. The Display will revert
back the current room humidity.
3. The clock symbol will illuminate in the Display to show the TIMER has been
set. After the pre-determined length of time has passed, the Humidifier will
automatically shut itself OFF. The TIMER Button may be pressed at any time to
show “time remaining” on the LCD Display.
4. If the clock symbol is not illuminated, the Humidifier is set to CONTINUOUS
RUN and will continue to operate as long as the Water Tank has an adequate
amount of water to run, or until the Humidifier reaches the desired set
humidity.
87
ADJUSTING THE FAN SPEED
NOTE: The Cool Mist Humidifier has a 3-Speed Fan that can be easily adjusted to provide
individual comfort.
1. Plug the Cool Mist Humidifier into a 120V AC electrical outlet.
2. The Display will show LOW FAN. Each time the ON/OFF/FAN Button is pressed, the
Display will advance from LOW (1 Bar) to MEDIUM (2 Bars) to HIGH (3 Bars) FAN
Speeds. The Fan will begin to operate immediately.
3. Press the ON/OFF/FAN Button to turn the unit OFF.
ADJUSTING THE HUMIDITY
NOTE: The Cool Mist Humidifier allows you to adjust humidity levels between 30% to 90%.
For maximum comfort, the recommended humidity level is between 40% and 50%.
1. When the Cool Mist Humidifier is plugged in, the Display will show the current
room humidity.
2. Press the ON / OFF Button to turn the unit ON. .The preset humidity level will
be shown.
3. To adjust the current room humidity, press ‘
+
’ or ‘
-
’ Button to increase or decrease
the humidity level. Each time the Button is pressed, the SET humidity level % on
the right side of the LCD Display will increase or decrease 1%. Hold the Button to
advance the setting continuously. When the desired humidity level is shown,
release the Button.
NOTE: If the current room humidity is greater or equal to the preset humidity level, the unit
will not operate.
NOTE: If moisture forms on the walls or windows, turn the Humidifier OFF.
HARD WATER
Hard water contributes to inefficient humidifier results. Hard water forms a scale of
limescale deposits that can cause a film on the Water Basin and Water Tank and cause
the water to become cloudy.
NOTE: In areas where tap water is hard, It is recommended that distilled water be used.