Thermo Products GMC-85 Furnace User Manual


 
All installations and services must be performed by qualified service personnel.
41
VI. USER INFORMATION SECTION
A. WARNINGS AND CAUTIONS:
: If you suspect there is a problem with the furnace, pertaining to the venting
system or any other related problem, immediately contact a qualified service agency. If a
service agency is not available, contact your fuel supplier.
: Personal injury or property damage could result from major repair or service
of this furnace by anyone other than a qualified contractor. The user should only perform
the routine maintenance described in the user section of this manual.
: The area around the furnace should be kept free and clear of combustible
materials, especially papers and rags.
: Never burn garbage or refuse in your furnace. Never try to ignite oil or gas by
tossing burning papers or other material into the furnace.
: Do not attempt to start the burner when:
1. Excess oil or gas has accumulated,
2. The furnace is full of vapors,
3. The combustion chamber is very hot.
If one or more of these conditions exist, contact a qualified service person.
: Do not block or obstruct air openings on the furnace casing. Do not block or
obstruct air openings communicating within the area in which the furnace is installed.
: Do not allow the outside air intake to be blocked or obstructed by vegetation,
ice, snow, or any other materials.
: Do not use this furnace if any part has been underwater. Immediately call a
qualified service agency to inspect the furnace and to replace any part of the electrical or
control system which has been underwater.
: Should overheating occur or the fuel supply fail to shut off, shut off the
manual fuel supply valve to the furnace before shutting off the electrical supply.