Filter
Top Products
Page 20 Four-Cycle Engine • Vertical Crankshaft • Air-Cooled 181-1215-14
V. Removal and Installation-Type “C” Air Cleaner
1. Turn cover counterclockwise to remove.
See Figure 50.
2. Remove paper filter from flange. See "II. Servicing
Paper Filters" instructions on page 19. Afterward, con-
tinue reading instructions below.
3. Discard paper filter.
4. Clean cover and flange thoroughly.
5. Install new paper filter into cover.
6. Position cover and filter against flange with tab on
cover inserted into lower left corner of slot in flange.
7. Push cover firmly against flange and turn
clockwise as far as it will go.
8. Be sure retainers are locked around flange.
VI. Removal and Installation-Type “D” Air Cleaner
1. Remove cover by pulling tab “A” away from body while
lifting cover upward. See Figure 51.
2. Inspect filter(s) for discoloration or dirt accumulation.
If either is present, see "I. Servicing Foam Filters"
instructions on page 18 and/or "II. Servicing Paper
Filters" instructions on page 19. Afterward, continue
reading instructions below.
3. Discard paper filter.
4. Clean inside of cover and body thoroughly.
5. Install foam filter(s) and new paper filter.
6. Install cover by hooking slot of cover over tab “B” on
body.
7. Push cover down, snapping cover onto body securely.
Figure 50. Air Cleaner Type “C” Assembly
1. Retainer
2. Slot
3. Flange
4. Paper Filter
5. Tab
6. Cover
1
2
34
56
1
Figure 51. Air Cleaner Type “D” Assembly
1. Tab “B”
2. Foam Filter
3. Slot
4. Cover
5. Tab “A”
6. Paper Filter
7. Body
1
2
3
4
5
6
7