Filter
Top Products
REV. F 5-1-01 5 P/N 99101100
5. Do not mount electrical controls (on/off switches, timer, etc.) over the filter. You need to be able to
stand clear of the filter when starting the pump.
6. Attach the hair and lint pot to the front of the pump. This is an O-ring seal fitting that requires hand
tightening only. (OVER TIGHTENING CAN RESULT IN DAMAGE TO THE O-RING SEAL)
7. Install the threaded fitting, see Diagram 3 – Figure 1, into the suction port of the pump. This is an
O-ring seal fitting that requires hand tightening only. (OVER TIGHTENING CAN RESULT IN
DAMAGE TO THE O-RING SEAL)
8. Install the threaded return fitting into the filter outlet port, see Diagram 3 – Figure 2, making sure that
the O-ring is in place in the filter body. Tighten this connection by hand until tight. If water leakage
occurs at this connection after installation, adjust connection with a wrench making sure not to exceed
1/4 of a turn. (OVER TIGHTENING CAN RESULT IN DAMAGE TO THE FILTER)
9. Connect black hoses to the equipment and the pool with
the clamps provided.
a. Connect the skimmer suction port from the pool to
the pump inlet.
b. Connect the filter outlet port to the return fitting of
the pool, see Figure 1.
c. Install the High Flow™ air relief valve, see Diagram
2 – Detail C, into the top of the filter tank lid. This is
an O-ring seal that requires hand tightening only.
d. Install the pressure gauge, see Diagram 2 – Detail D,
using the Teflon tape provided. Wrap the threads of
the pressure gauge with three layers. Install the
gauge into the top of the filter tank until tight.
10. Never install a pump in this system that exceeds the
maximum pressure of this filter,
see data label.
11. If using the optional Chlorinator Base, knockout the
two slots on the system base with a hammer and
screwdriver.
12. Slide the two tabs on the Chlorinator Base into the slots
on the system base; see Diagram 4.
Diagram 3.
To
Skim-
mer
To
Return
Fitting
Tabs
Diagram 4.
Slots
Skimmer
Figure 1.
Figure 2.
Return
POOL