Swann SW347-WA2 Home Security System User Manual


 
222
FCC Verifi cation:
NOTE: This equipment has been tested and found to comply with the limits for
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are de-
signed to provide reasonable protection against harmful interference in a residen-
tial installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio or television reception, which can be deter-
mined by turning the equipment off and on, the user is encouraged to try to cor-
rect the interference by one or more of the following measures:
· Reorient or relocate the receiving antenna
· Increase the separation between the equipment and the receiver
· Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected
· Consult the dealer or an experienced radio/TV technician for help
IMPORTANT NOTE: Prohibition against eavesdropping
Except for the operations of law enforcement offi cers conducted under lawful
authority, no person shall use, either directly or indirectly, a device operated pursu-
ant to the provisions of this Part for the purpose of overhearing or recording the
private conversations of others unless such use is authorized by all of the parties
engaging in the conversation.
WARNING: Modifi cations not approved by the party responsible for compliance
could void user’s authority to operate the equipment.
IMPORTANT SAFETY INSTRUCTIONS:
· Make sure product is fi xed correctly and stable if fastened in place
· Do not operate if wires and terminals are exposed
IMPORTANT: Regarding Your Passcode
The Default Passcode is 1235.
In the event that the default settings for the alarm system are restored,
or you accidentally lock the system before setting a passcode of your
own, then this is the code you’ll need to unlock the system.
We strongly recommend choosing a new password as soon as possible.
Before You Begin
2 19
Warranty Information
Swann Communications warrants this product against defects in workmanship
and material for a period of one (1) year from it’s original purchase date. You
must present your receipt as proof of date of purchase for warranty validation.
Any unit which proves defective during the stated period will be repaired
without charge for parts or labour or replaced at the sole discretion of Swann.
The end user is responsible for all freight charges incurred to send the product
to Swann’s repair centres. The end user is responsible for all shipping costs
incurred when shipping from and to any country other than the country of
origin.
The warranty does not cover any incidental, accidental or consequential
damages arising from the use of or the inability to use this product. Any costs
associated with the fitting or removal of this product by a tradesman or other
person or any other costs associated with its use are the responsibility of the
end user. This warranty applies to the original purchaser of the product only
and is not transferable to any third party. Unauthorized end user or third party
modifications to any component or evidence of misuse or abuse of the device
will render all warranties void.
By law some countries do not allow limitations on certain exclusions in this
warranty. Where applicable by local laws, regulations and legal rights will take
precedence.
Swann Communications USA Inc.
12636 Clark Street
Santa Fe Springs CA 90670
USA
Swann Communications
Unit 13, 331 Ingles Street,
Port Melbourne Vic 3207
Swann Communications LTD.
Stag Gates House
63/64 The Avenue
SO171XS
United Kingdom