Filter
Top Products
NOTE: DIAGRAMS & ILLUSTRATION NOT TO SCALE.
11
Figure 23
Remote Control Kit
The Model RCL adds the convenience of re-
mote control for your appliance. The kit in-
cludes a wireless, hand held transmitter and a
receiver that replaces the wall switch. This
special receiver permits either manual or re-
mote control modes. Both receiver and trans-
mitter operate on standard 9 volt batteries (not
included). Refer to the RCL installation instruc-
tion for specific details.
Wall Switch Kit
An optional wall switch kit can be installed
along with all vent-free appliances. The kit
consists of a standard UL wall switch with
cover plate. This kit provides for remote (wall)
operation of the appliance. Replace the wall
switch and cover plate of this kit with the
components of the FWSK and you can have true
remote control of your vent-free appliance,
turning it on and off from your favorite easy
chair. The wall switch kit should be installed
along with the appliance. Refer to
Figure 14
and Step 6 for detailed installation instructions.
Rocker Switch Kit
An optional rocker switch kit can be installed
directly on all VF5000/VF6000 series appli-
ances to provide for On and Off operation in lieu
of a wall switch. This kit is designed to install in
the lower control compartment out of view and
is perfect for use in high volume areas such as
lobbies and model homes where limited access
to the appliance On/Off switch is desirable. This
kit can be retrofitted to previously installed
appliances and may be temporarily installed in
place of other switch circuitry.
Decorative Volcanic Stone
The decorative volcanic stone, Model FDVS,
can be used to enhance the look of your appli-
ance. Spread the decorative volcanic stone
evenly around the bottom of the firebox.
Refractory Liner Kit
One of the most beautiful enhancements you can
make to this appliance is the addition of refrac-
tory liners. The refractory liner kit includes tan
ceramic fiber panels for the rear and side walls of
the firebox. The ceramic fiber panels have brick-
like features in relief. To install the three panels,
simply place them in position against the firebox
walls. This kit can be retrofitted into previously
installed appliances.
Glass Door Kit
Optional glass door kits are available for use
with both the VF5 and VF6 appliances. These
doors elegantly provide protection for the logs
while helping to prevent the buildup of con-
taminates such as pet hair, carpet lint and dust
on the burner ports. Use the GDK-5 with VF5
appliances and the GDK-6 with VF6 appli-
ances.
Solid Brass Hood Kit
An attractive solid brass hood kit is available
for use with these VF appliances. The brass
hood kit is designed to be fitted to your appli-
ance above the door. In addition to providing
an aesthetically pleasing appearance to your
appliance installation, the hood reduces heat
effects to decorative mantles and finish mate-
rials located directly above the fireplace open-
ing. The hood kit includes the necessary
attaching hardware. This kit can be retrofitted
to previously installed appliances.
Solid Brass Louver Kit
Solid brass louvers are available for use with
these appliances. These louvers are designed
to replace the standard black louvers that are
provided with the appliance. The brass louver
kit includes four (4) louvers that simply snap
into place. They provide a touch of elegance to
the VF appliance. This kit can be retrofitted to
previously installed appliances.
Grounded
to Appliance
Blower Motor
Motor Plug
Receptacle
120V
Appliance Junction Box
Wall Thermostat Kit
A wall thermostat kit is available for use with
these appliances. The wall thermostat is de-
signed to be wired directly to the appliance
millivolt gas control circuit and provide auto-
matic On/Off control of the appliance to main-
tain a desired temperature within the room.
Brass Square Surround Kit
Decorative brass square surround kits are avail-
able for use with these appliances. The BSK-5
and BSK-6 are designed to attach directly to the
front face of the appliance at its extreme edges.
The brass square surround kits provide a pic-
ture frame finish for the appliance 2-1/2" wide.
Use the BSK-5 with VF5 appliances and the
BSK-6 with VF6 appliances. The brass square
surround kit can be retrofitted onto previously
installed appliances.
Screen Panel Kit
An optional screen panel can be installed on the
VF5000/VF6000 Series Units. This screen panel
is easy to install. This kit can be retrofitted to
previously installed VF5000/VF6000 appliances.
One Piece Arch Kit
A one piece complete door arch kit is available
for use with VF appliances fitted with the op-
tional GDK-5/6 door. This kit is easy to install
and does not require hardware to attach it to a
previously installed optional door frame. The
kit can be retrofitted to previously installed
appliances.
Gas Flex Line with Valve
A gas flex line kit is available to aid in attaching
the appliance to the gas supply. This kit can
only be used where local codes permit. The kit
includes a 1/2" NPT to 3/8" flare in line shut-off
valve, a 12" flex line 3/8" female flare through
and a 3/8" flare to 3/8" NPT fitting. The compo-
nents of this kit are rated for both natural and
propane gas. This kit is designed to be used as
an aid in installing the appliance.
WARNING: CHILDREN AND ADULTS
SHOULD BE ALERTED TO THE HAZARDS
OF HIGH SURFACE TEMPERATURES. USE
CAUTION AROUND THE APPLIANCE TO
AVOID BURNS OR CLOTHING IGNITION.
YOUNG CHILDREN SHOULD BE SUPER-
VISED WHEN THEY ARE IN THE SAME
ROOM AS THE APPLIANCE.