Filter
Top Products
Specifications
3
Model Number WA-7500M
Cooling Capacity 7,500 BTU/hr
Power Consumption 620W/6A
Humidity Removal Capacity 46 Pts./day
Recommended Room Size* 200 sq. ft.
Power Supply 120V / 60Hz / 1 Phase
Compressor Rotary
Refrigerant R-22
Fan Speed 2
Timer WA-7500M: 1- 8 hours
Thermostat 64°F - 90°F
Net Weight 66 lbs.
Dimensions 16"W x 16"D x 30"H
Working Temperature Cooling 64°F to 110°F
REMARKS:
1. The data may vary, please refer to the rating label on the back of the unit.
2. The above conditions are measured at:
Cooling - Indoor: RT 81°F, RH 60%
* Uninsulated rooms such as sunrooms, garages, or attics should be less than 200 sq. ft.
Drainage
10
Drain Pipe
Original
Water Tube
Extended
Water Tube
(OD: 3/4")
Rubber Plug
Drain Knob
Water Hole
Drain Knob
Rubber Plug
During the process of cooling, some water will be extracted
from the air into the unit. Most of this water is used to cool
the unit and make it run more efficiently. This is a feature not
found in most Portable Air Conditioners. If the unit is operated
in VERY HUMID air, water will collect in the container inside the
unit. If the water container is full, the compressor will stop, but
the fan will continue to circulate the air. The POWER indicator
will blink to inform you to empty the internal container. To make
the cooling function work again, please empty the water by one
of the following methods:
By the Draining into a Container
Use a Shallow Container or Dish
1. Turn off the unit.
2. Position a flat container or dish under the drain hole.
Do not allow the water to drip continuously into the container,
as it might easily overflow.
3. Remove the drain knob & rubber plug from the drain hole.
The condensed water will drain out automatically.
4. When the container is almost full, replace the rubber plug
into the drain hole to stop the water. Empty the container.
5. Repeat steps 2, 3 & 4 until all the condensed water is emptied.
6. Once all the condensed water has been removed,
replace the rubber plug into the drain hole firmly.
The Full Water indicator should be off now.
7. Replace the drain knob.
By Water Tube (Continuous Drainage)
1. Remove the drain knob and rubber plug and keep them
for future use.
2. Connect a suitable water tube
(of 3/4" internal diameter - supplied) to the water hole.
The condensed water will drain out automatically.
3. If you want to extend the water tube you can connect
it with another tube (outside diameter 3/4").