Filter
Top Products
9
1. Place the heater on a flat level surface,
approximately 1 metre from any wall or
other objects such as furniture, curtains,
plants or combustible material, and ensure
that the air intake and outlet are clear of
obstructions.
Note: For most efficient heating, place the
heater on the floor where the air is cooler,
near an outside door, the bottom of a
staircase, or where colder air is most likely
to be entering the room.
2. Insert the plug into a 230-240V power
outlet and turn the power on. The power
light will illuminate.
3. To operate the heater, select HEAT on
the mode dial. Rotate the thermostat dial
to select the desired temperature setting.
Once the selected temperature level has
been reached, the thermostat will
constantly vary the heat output to
maintain it.
4. To operate the fan, select FAN on the
mode dial. Rotate the thermosat dial to
minimum.
5. To switch the heater off, select OFF on the
mode dial.
6. Switch the power off at the power outlet
and unplug the heater when not in use.
Using your heater (continued)
MF1500 Micro Furnace Ceramic Disc Heater
Ensure the heater is switched off and
disconnected from the power outlet before
cleaning.
Carefully wipe the exterior of the heater with
a soft damp cloth and dry thoroughly.
Cleaning the dust filter
The dust filter collects dirt and dust from the
air circulating through the heater.
To clean the filter, remove from the unit and
rinse under warm water. Allow to dry
completely before replacing on the heater.
Storage
Store your heater in a cool dry place when
not in use. Store the heater in its carton if
possible.
Care and cleaning