Filter
Top Products
11
Wall mounting
1. Before wall mounting your heater, remove
the wheels.
2. Mark the screw location on the wall,
approximately 1 metre from the floor.
Note: The heater must be fixed no lower
than 6.5cm above the floor and no higher
than 1.8 metres above the floor. The heater
must also be fixed at least 1 metre from
both the corner and ceiling (refer to figure
4 below).
Drill the first hole using a suitable drill bit.
Note: Any electrical appliances to be fitted
in a bathroom should be installed by a
qualified electrician in accordance with
Australian/New Zealand Standard Wiring
Rules. Portable heaters should not be used
in a bathroom.
Heaters that can be permanently fixed
must be installed so that any controls
cannot be reached by a person using a
bath or shower, as shown in Figure 5.
3. Insert one of the screw anchors into
the hole.
4. Put the mounting support on the wall over
the hole and screw it into place.
5. Mark the second screw location,
approximately 138mm from the first hole,
and 1 metre from the floor. Drill the second
hole.
6. Insert the second screw anchor into the
hole.
7. Place the mounting support over the second
hole and screw it into place. Tighten both
screws.
8. Lift the heater and position over the screws.
Attaching the wheels
Fix each wheel support in position with the
screws provided.
Wall Mounting and Attaching
the Wheels
Figure 4
Figure 5