Filter
Top Products
Before first use
Remove any packaging or marketing materials
that may be attached to the mop.
Partially fill and then empty the water tank to
remove any foreign particles that may remain
in the tank following the manufacturing
process.
Remove the metal release pin from the
cleaning brush and store safely for later use.
Filling the Eco Mop with water
Before filling with water, ensure that the
steam on/off switch on the handle is in
the off position (
) and the power cord is
removed from the power outlet.
1. Position the mop securely at an angle close
to the horizontal with the water tank cap
facing upward. Remove the cap.
2. Slowly fill with at least 250ml of clean tap
water. Do not exceed the maximum water
level indicated (1 litre).
3. Replace the cap and tighten.
Using the Eco Mop
Ensure that the steam on/off switch is in the
off position (
) and the mop is unplugged
from the power outlet before fitting or
changing attachments.
1. Fit the desired cloth to the utility head by
stretching the elasticised cloth over the
head, ensuring it is evenly fitted and snug.
Note: Do not use the utility head without a
cloth attached as this may cause damage to
surfaces.
2. Attach the utility head with cloth to the
mop by aligning the hole in the end of the
attachment with the pop-out lock button
on the end of the mop. Depress the button
to allow the attachment to fit over it. Push
the attachment onto the mop until it is
securely in position and the button pops
out, locking the attachment in place.
3. Place the mop on the tray provided.
4. Insert the plug into a 230/240V power
outlet and turn the power on at the
wall. The light on the mop handle will
illuminate, indicating that the steam
generator is heating. Once the light goes
out (approx. 50 seconds), the mop has
reached the optimum temperature for
producing steam and is ready to use.
Note: The mop is switched on and heating
once connected and turned on at the power
outlet, even if the steam on/off switch is in
the off positon (
).
5. Move the steam on/off switch on the
handle to the on position (
). During use,
the light will cycle on and off as the mop
maintains the required temperature.
Note: When the steam on/off switch is moved
to the on position (
), the mop may drip
a small amount of water as it begins to
produce steam. The mop will then start to
produce steam within seconds, so ensure
that it is resting on the tray whilst heating or
cooling or at any time the mop is stationary
for more than 10 seconds, to avoid damage
to surfaces. Should calcification occur, the
white ‘halo’ effect can be removed using a
decalcifying product or with a few drops of
vinegar applied directly to the area.
6. Slowly pass the mop back and forth over
the surface to be cleaned. To remove
stubborn stains, hold the mop over the
area for several seconds.
Using your Eco Mop
7