Filter
Top Products
7
Activating the Oscillation function
Press the OSC button on the control panel or
remote to activate the oscillation. The heater
will continue to oscillate from side to side,
distributing warm air around the room, until
the OSC button is pressed again.
The body of the heater will stop oscillating in
its current position. To align the heater body
and base, press the OSC button to activate
the oscillation, and press it again when the
two parts are aligned.
Setting the timer
1. Set the heater to the desired heat or
temperature setting as per the instructions
above.
2. Press the timer button once to set the
heater to switch off after one hour, twice
for 2 hours and so on, up to 8 hours. The
timer icon will appear on the screen, as
shown in figure 3. The heater will continue
operating for the selected number of hours
and will then switch off automatically.
Using the remote control
The buttons on the remote control function
in the same way as the buttons on the
control panel. It is powered by 2 x AAA
batteries.
Note: when using the oscillating function in
AUTO mode the heater will stop oscillating
when the selected temperature is reached
and the unit cycles off. It will resume
oscillating when the heater cycles back on to
maintain the selected temperature level.
Using your Oscillating Digital Ceramic Heater (continued)
AUTO
ROOM TEMP
Fig. 3