Filter
Top Products
PLEASE READ AND SAVE THESE
IMPORTANT SAFETY INSTRUCTIONS
FEATURES - OPERATIONS
CLEANING / STORAGE
Thank you for purchasing this Holmes
®
product. We
understand the value of quality and are committed to
making superior products that stand the test of time. We
trust this product will exceed your expectations of quality
and reliability. We hope that you enjoy this product and
will consider purchasing another Holmes
®
product in the
future. To see our full product line or if you have any
questions or comments about this product, please visit our
website at: www.holmesproducts.com.
When using electrical appliances, basic safety precautions
should always be taken including the following:
1. Read all instructions before using this appliance.
2. Use fan only for purposes described in the instruction
manual.
3. To protect against electrical shock do not immerse unit,
plug or cord in water or spray with liquids and plug the
appliance directly into a 120V AC electrical outlet.
4. Close supervision is necessary when any appliance is
used by or near children.
5. Unplug from outlet when not in use, when moving fan
from one location to another, before putting on or
taking off parts and before cleaning.
6. Avoid contact with moving parts.
7. Do not operate in the presence of explosive and/or
flammable fumes.
8. To avoid fire hazard, NEVER place the cord under rugs
or any parts near an open flame, cooking or other
heating appliance.
9. Do not operate any appliance with a damaged cord or
plug after the appliance malfunctions, or has been
dropped/damaged in any manner.
10. The use of attachments not recommended or sold by
the appliance manufacturer may cause hazards.
11. Do not let the cord hang over the edge of a table,
counter or come in contact with hot surfaces or leave
exposed to high traffic areas.
12. Do not use outdoors.
13. To disconnect, grip plug and pull from wall outlet.
Never yank on cord.
14. Always use on a dry, level surface.
15. Do not operate fan until fully assembled with all parts
properly in place.
16. This product is intended for household use ONLY and
not for commercial or industrial applications.
17. WARNING: To reduce the risk of electrical shock and
injury to persons, do not use in window.
18. WARNING: To reduce the risk of fire or electric
shock, DO NOT use this fan with any solid-state speed
control device.
PLEASE READ AND SAVE
THESE IMPORTANT
SAFETY INSTRUCTIONS
ASSEMBLY INSTRUCTIONS
1. Remove the Rear Grill Screw from the Motor Housing.
2. Secure the Rear Grill to the Motor Housing with the
Rear Grill Mounting Nut. Refer to Figure 2 for the
proper alignment of the Rear Grill to the Motor
Housing.
3. Slide the Fan Blade over the Motor Shaft. Refer to
Figure 3 for the correct alignment of the Blade to the
Motor Shaft.
4. Secure the Fan Blade to the Motor Shaft with the Blade
Cap. Refer to Figure 3.
5. Attach the Front Grill to the Rear Grill by positioning
the Hanging Clip of the Front Grill over the Rear Grill.
Close the remaining four Grill Clips on the Front Grill
over the Rear Grill. Refer to Figure 4.
OPERATING INSTRUCTIONS
Fan Speed Knob
O=Off, III=High, II=Medium, I=Low
Oscillation Knob ( )
Push, Pull=Oscillation On, Off
CLEANING/MAINTENANCE
INSTRUCTIONS
Follow these instructions to correctly and safely care for
your fan.
• Always unplug the fan before cleaning or disassembling.
• Be sure to clean your fan with a soft cloth moistened
with a mild soap solution.
• Do not allow water to drip on or enter into the Motor
Housing.
• Do not use gasoline, thinner, or benzene as a cleaner.
• Lightly run a vacuum cleaner nozzle over the fan grills
to remove any dust or dirt that may have accumulated.
Fan Blade Cleaning
Make sure the fan is unplugged before disassembling and
cleaning the Blade. Unclip and remove the Front Grill.
Wipe the Blade with a soft cloth moistened with a mild soap
solution. DO NOT allow any liquid to drip or enter the
Motor Housing. Re-clip the Front Grill onto the fan. Make
sure all parts are secured prior to operating the fan.
FAN STORAGE INSTRUCTIONS
• Store your fan in the original box or an appropriately
sized box.
• Protect the fan head from dust.
•Store your fan in a dry location.
THIS APPLIANCE HAS A POLARIZED PLUG (one blade is wider than the
other). To reduce the risk of electric shock, this plug is intended to fit in
a polarized outlet only one way. If the plug does not fit fully in the
outlet, reverse the plug. If it still does not fit, contact a qualified
electrician to install the proper outlet.
DO NOT ATTEMPT TO MODIFY THIS PLUG OR DEFEAT THIS
SAFETY FEATURE IN ANY WAY.
A
FBCD
H
E
J
G
I
L
K
M
L
Figure 1
A. Logo Plate
B. Front Grill
C. Blade Cap
D. Fan Blade
E. Rear Grill Mounting Nut
F. Rear Grill
G. Motor Shaft
H. Motor Housing
Assembly
I. Oscillation Knob
J. Grill Mount
K. Speed Control Knob
L. Assembly Post
M. Base
N. Grill Clips (See Figure 4)
O. Hanging Clips (See
Figure 4)
1
2
Figure 3
1
2
Figure 4
O
N
Figure 2
E
HAOF126506EM1.qxd 10/24/06 14:20 Page 2