Sunbeam 646 Humidifier User Manual


 
INSTRUCTIONS
Please refer to the directions below for inserting and removing the humidifier
motor assembly. Unit may make vibrating noise if motor assembly is not
placed properly on humidifier water reservoir.
To remove motor assembly from water reservoir lift motor assembly directly
upwards from water reservoir. To insert motor assembly onto water reservoir
set motor assembly gently on ridge of water reservoir. Be sure motor
assembly cannot move around on water reservoir.
Warning: Protect yourself against electrical shock. Always unplug your
humidifier when not in use, and before cleaning, rinsing, filling
or moving. Unit will reach maximum output after about five
uses. If greater output is desired, warm tap water may be used.
OPERATING INSTRUCTIONS
1. Always rinse and empty the water container before each
filling and after each use.
2. Before filling container, unplug the unit, lift top of unit and
place upside down to avoid damaging the impeller stem.
3. Fill with cool tap water to fill line indicated on the outside of
the bucket. There are two fill lines located on the back side
of the reservoir. The first line is half full and the top line is
full. Do not fill the reservoir higher than the top line. The half
full line is to be used for running the humidifier half the
normal running time. (Example: If your humidifier runs 20
hours when you fill it up, and you only want to fill 10 hours,
simply fill your humidifier to the first line.) Do not add
Figure 1
Full Line
medication of any type to the water in the container. After filling, replace
top as explained above.
4. Place the humidifier on flat hard surface. Do not place under a tent.
Do not direct the mist toward the patient or toward walls or furniture.
5. The power cord must be extended to its full length (unhanked;
not bunched up) to prevent overheating of the cord. Plug
humidifier into a 120 volt outlet only