Filter
Top Products
At the end of the testing interval, (up to 30 seconds) the display will indicate the
level of airborne allergens particles measured. If the display indicates a moder-
ate(yellow light) or high(red) level, the air cleaner will automatically turn on for
30 minutes. At the end of 30 minutes, the sensor will resample the air (blinking
green light). If the level of allergen particles detected by the sensor is less
than the sensitivity setting you selected, the air cleaner will remain off, and the
sensor will continue to constantly sample the air (blinking green light) until it
detects that the particle level has exceeded the sensitivity setting you chose.
TO RUN YOUR AIR (LEANER MANUALLY...
1. Turn the sensitivity setting to the OFF/manual position.
2. Choose one of the four fan speeds (sleep, low, medium, high).
The air cleaner will run continuously until you shut it off.
TO USE
THE
IONIZER...
Push down the ionizer button. The indicator light will come on. The
ionizer is now operating and will continue to operate whether
the air cleaner is on or off.
1. Place your air cleaner near the center of the room or in an area where the unit
can operate without impediments to the airflow.
2. Turn your air cleaner so that the Allergysmart detector can freely sample air (do
not put the detector in a corner or otherwise impede air flow to the detector).
3. Experiment with the location and sensitivity and fan speed settings on your unit.
If you feel that your home’s air continues to contain allergen particles after
running the unit at a low fan speed (sleep, low or medium) or at a lower
sensitivity setting (average or extra), try increasing the fan speed to medium
or high and/or increasing the sensitivity setting to extra or super. You can
also try repositioning the unit in your room. Remember that the higher the
sensitivity setting, with super being the highest, the lower the particle count
required to cause the unit to turn on. If you feel that the unit is running
too often, reduce the sensitivity setting (i.e. change the sensitivity setting
from super to extra or average).