Filter
Top Products
Install the Lavatory (cont.)
NOTE: You can also use other fastening devices of sufficient size
and strength.
Install the hanger bolts to the backing material. Thread the cap
nuts onto the two hanger bolts. Use a 9/16″ wrench to thread the
hanger bolts into the wall so 1″ (2.5 cm) of each bolt remains
exposed between the cap nuts and finished wall.
Remove the cap nuts.
Install the faucet and drain to the lavatory according to the
manufacturer’s instructions.
Move the pedestal and lavatory back into position and fit the
lavatory over the hanger bolts. Make sure the lavatory rests
directly on the pedestal and fits flat against the wall.
Remove the lavatory and set it aside.
CAUTION: Risk of product damage. Do not overtighten or
damage may occur.
Thread a washer and lag bolt through the pedestal hole and into
the floor until the washer contacts the pedestal. Tighten the lag
bolt until snug.
Move the lavatory back into position over the hanger bolts.
Double check the installation to be sure it is level and properly
positioned.
Install washers and cap nuts to the hanger bolts and tighten until
the washers contact the lavatory. Tighten the cap nuts until snug.
Connect and tighten the trap to the drain.
Complete the water supply connections to the faucet according to
the instructions packed with the faucet.
Clean up with a nonabrasive cleaner.
Care and Cleaning
Clean the outside surface of your vitreous china lavatory with mild
soap and warm water. Wipe the entire surface completely dry with a
clean, soft cloth. You may use soft abrasive cleaners when necessary to
clean your lavatory. Do not use strong abrasive cleaners, as they will
scratch and dull the surface.
If the surface becomes excessively dirty, use a general purpose cleaner
such as: Fantastik
®
All Purpose, Lysol
®
Basin, Tub and Tile Cleaner,
Soft Scrub
®
Multi Purpose, Scrub Free
®
Disinfectant Bathroom Cleaner,
Clorox Clean-Up
®
, Spic and Span Liquid, Comet
®
Liquid Bathroom
1021720-2-A 6 Sterling