State Industries Power Vent/Power Direct Vent Gas Models Water Heater User Manual


  Open as PDF
of 44
 
34
3. Changing the Display Units
Thedisplayinterfacetotheheaterhastheoptionofselectingbetween
degreesFahrenheitanddegreesCelsiusfortemperaturedisplays.
Thiscanbefoundinthe“DisplaySettings”menu.Alsointhismenu,
youmayadjusthowthebacklightoperatesandthecontrastofthe
LCD screen.
ACTION:
FromtheMainMenu,presstheDownbuttontohighlight"Display
Settings"thenpressSelect.
DISPLAY:
ACTION:
UsetheUPandDOWNbuttonstohighlightthedesiredsetting.Then
pressChange.Again,usetheUPandDOWNbuttonstoscrollthrough
theoptionsforthatsetting.
DISPLAY:
ACTION:
Press UpdatetoacceptthechangeorCancel torejectit.
DISPLAY:
4. Fault and Warning Conditions
Thiswaterheaterisequippedwithelectroniccontrolsthathavethe
abilitytomonitoralmostallaspectsofthewaterheateroperation.In
the case that there is an undesirable or unsafe condition that occurs,
the water heater controls will detect this condition and determine the
appropriateaction.PartofthisisdisplayingtheinformationontheLCD
inplaintextthataccuratelydescribestheconditionanddiagnostics
information that can be used to correct the issue.
Therearetwotypesofconditionsthatcanoccurduringoperation.These
areWarningsandFaults:
•Warnings: This is a non-safety related condition that the control has
detectedthatmaycausethewaterheatertooperateinalessthanoptimal
condition,butdoesnotposeasafetyconcern.
NOTE:Whentheseconditionsoccur,continuedheatingcycleswill
continueandtheheaterwillattempttoregulatethewaterinthetankto
the Operating Set Point.
Example of a Warning:
• Faults: This is a safety related condition that has been detected
by the heater.
NOTE: When these conditions occur, the water heater will not
continueanyfurtherheatingcyclesandthewaterwillnolongerbe
heateduntiltheconditioniscorrectedand,inmostcases,powerhas
been cycled.
Example of a Fault:
Advanced Diagnostics Information
Whenafaultorwarninghasbeendeclared,advancedinformationcanbe
foundinthecontrol.BypressingtheAdvancedbutton,detailedinformation
canbefoundregardingdiagnosingandresolvingtheproblem.
WARNING: Usage of the Advanced information requires ability
equivalent to that of a licensed tradesmen in the eld involved.
5. Access to the Current Fault or Warning
Whenafaultorwarning hasbeen detectedbythe control,itwill
automaticallybedisplayedonthescreenandthebacklightwillblink.If
youchoosetoleavethecurrentfaultorwarningbypressingtheBackkey,
youcanalwaysreturntothefaultscreenthroughthemenu.
 previous next