Filter
Top Products
6
Fitness Bike
XBR95
1. Slide the Computer Cable (44), Handlebar resistance control cable (148), and Hand pulse cable (133) through
the bottom of the Console Mast Cover (31) and then the bottom of the Console Mast (2). Make sure the
Console Mast Cover is correctly oriented (see illustration).
2. Install the Console Mast (2) into the receiving tube (make sure not to pinch cables; damage to the electronics
could occur) of the Main Frame (1). Insert two Hex Head Bolts (68) and two Flat Washers (76) on each side.
Insert two Hex Head Bolts and two Curved Washers (83) on the front. Tighten all six bolts rmly with the
Wrench (112).
3. Remove the white Styrofoam pad (factory installed to prevent bolts from being accidentally dropped into the
console mast tube).
4. Attach the Handle Bar Assembly (3) onto the Console Mast (2) bracket with the two Hex Head Bolts (68),
two Split Washers (82), and two Flat Washers (76). Completely tighten with the wrench (112).
5. Insert the Computer Cable (44), Handlebar resistance control cable (148), and Hand Pulse Cable (133) into
their respective connectors in the back of the Console Assembly (19). Attach the
console onto the mounting plate with four Phillips Head Screws (99). Tighten with the Phillips Head Screw
Driver (114).
HARDWARE
STEP 2: Console Mast
#82.8 x 1.5T
Split Washer
(2 pcs)
#83.5/16” x 19 x 1.5T
Curved Washer
(2 pcs)
#76.5/16” x 18 x 1.5T
Flat Washer
(6 pcs)
#68.5/16” x 15mm Hex
Head Bolt
(8 pcs)
#99.M5 x 12mm
Phillips Head Screw
(4 pcs)