Filter
Top Products
3. Place the leg in the desired position, then
markandpre-drillholesforthemounting
hardware you have chosen. Unless you
intendtodoso,takecaretoavoiddrillingall
the way through the bench top.
4. Use your chosen hardware to secure the leg
to the bench top, as shown in Figure 4.
5. Repeat Steps 2–4 for the second leg.
6. With additional people to help, carefully turn
the bench over.
7. Placeyourshelfontotheshelfbrackets,as
shown in Figure 5,thenmarkdrillholes
throughtheholesontheshelfbrackets.
Figure 4. Securing leg to bench top.
Mounting Hardware
Figure 5. Shelf placement.
Shelf
Shelf Bracket
Theprocedurethatfollowsdescribesthegeneral
steps required for assembly. Since the bench top
and shelf are not included, individual assembly
steps will vary.
Assembly
To assemble the workbench:
1. Place a piece of cardboard or other protective
material on a flat, level, hard floor, then
placeyourbenchface-downonit.
Figure 3. Leg placement.
Leg
Bench
Top
Cross-brace
Mounting Tab
The legs included in this kit weigh over 100
lbs. each. In the steps that follow, make sure
the legs are constantly stabilized to prevent
them from falling until they are secured to the
bench top in Step 4. Failure to do so could
allow the legs to fall, resulting in crushing
injuries, laceration injuries, or death.
2. With the help of one or two additional
people,placeoneofthelegsupside-down
ontotheinvertedbenchtop,makingsurethe
cross-bracemountingtabpointstowardthe
middle of the bench as shown in Figure 3.
Never attempt to weld onto the cast iron legs
or drill into them. Doing so can compromise
their strength and will void the warranty.
x 4
-2-
For Models Mfg. Since 7/10
Model SB1354
INSTRUCTIONS