Filter
Top Products
Firewall > Access Rules
427
SonicOS Enhanced 4.0 Administrator Guide
Step 13 If you would like for the access rule to timeout after a period of TCP inactivity, set the amount
of time, in minutes, in the TCP Connection Inactivity Timeout (minutes) field. The default
value is 5 minutes.
Step 14 If you would like for the access rule to timeout after a period of UDP inactivity, set the amount
of time, in minutes, in the UDP Connection Inactivity Timeout (minutes) field. The default
value is 30 minutes.
Step 15 Specify the number of connections allowed as a percent of maximum number of connections
allowed by the SonicWALL security appliance in the Number of connections allowed (% of
maximum connections) field. Refer to
“Connection Limiting Overview” on page 429 for more
information on connection limiting.
Step 16 Select Create a reflexive rule if you want to create a matching access rule to this one in the
opposite direction--from your destination zone or address object to your source zone or
address object.
Step 17 Click on the QoS tab if you want to apply DSCP or 802.1p Quality of Service management to
traffic governed by this rule. See
“Firewall > QoS Mapping” section on page 467 for more
information on managing QoS marking in access rules.
Step 18 Under DSCP Marking Settings select the DSCP Marking Action. You can select None,
Preserve, Explicit, or Map. Preserve is the default.