SonicWALL TZ 180 Humidifier User Manual


 
SonicPoint > SonicPoints
397
SonicOS Enhanced 4.0 Administrator Guide
that the SonicPoint can communicate with an authentication server for WPA-EAP support.
SonicOS will then use the profile associated with the relevant Zone to configure the 2.4GHz
and 5GHz radio settings.
Modifications to profiles will not affect units that have already been provisioned and are in an
operational state. Configuration changes to operational SonicPoint devices can occur in two
ways:
Via manual configuration changes – Appropriate when a single, or a small set of changes
are to be affected, particularly when that individual SonicPoint requires settings that are
different from the profile assigned to its Zone.
Via un-provisioning – Deleting a SonicPoint unit effectively un-provisions the unit, or clears
its configuration and places it into a state where it will automatically engage the provisioning
process anew with its peer SonicOS device. This technique is useful when the profile for a
Zone is updated or changed, and the change is set for propagation. It can be used to update
firmware on SonicPoints, or to simply and automatically update multiple SonicPoint units in
a controlled fashion, rather than changing all peered SonicPoints at once, which can cause
service disruptions.
Updating SonicPoint Settings
You can change the settings of any individual SonicPoint list on the Sonicpoint > SonicPoints
page.
Edit SonicPoint settings
To edit the settings of an individual SonicPoint:
Step 1 Under SonicPoint Settings, click the Edit icon in the same line as the SonicPoint you want
to edit.
Step 2 In Edit SonicPoint screen, make the changes you want. The Edit SonicPoint screen has the
following tabs:
General
802.11a Radio
802.11a Advanced
802.11g Radio
802.11g Advanced