Filter
Top Products
ASSEMBLY & INSTALLATION (CONT.)
8
Placing the Unit Inside a Normal Window
1. Place the air conditioner on the sill with the bottom
mounting rail against its back edge. Center the air con-
ditioner and close the window securely behind the top
mounting rail. The air conditioner should be slightly
tilted to the outside area. Use a level; about a 1/3 bub-
ble will be the correct case slant to the outside. (See
FIG. 5 & FIG. 6)
2. Once the air conditioner is placed, extend both the left
and right accordion panels to the width of the window
SEE FIGURE 7).
3. Place the frame lock between the frame extensions
and the window sill as shown (FIG. 8). Drive
3/4” (19mm) locking screws through the frame lock and
into the sill (FIG. 9). NOTE: To prevent window sill from
splitting, drill 1/8” (3mm) pilot holes before driving
screws.
Accordion Panel Installation
Now that you have installed the top rail, you can now install
the accordion panels on each side.
1. Place the air conditioner on a hard flat surface.
2. Locate the accordion panels in the box.
3. Gently pull the free end of the accordion panel (See
FIG. 2). Do this for both panels.
4. Slide the free end of the accordion panel into the side
panel of the air conditioner (See FIG. 3 & 3A). Do this
for each side.
5. Once the accordion panels are slid into place, make
sure you leave enough space to slip on the top and
bottom rails (See FIG. 4). Now, slide the top and bot-
tom of the side panels inside top and bottom rails (See
FIG. 4A). Adjust the panels until they fit securely inside
the rails
FIG. 2
FIG. 5
FIG. 6
FIG. 7
FIG. 3
FIG. 4A
FIG. 3A
FIG. 4
FIG. 8
FIG. 9