Soleus Air KC-15U Air Conditioner User Manual


 
Recommended ground method
For your personal safety, this air conditioner must be grounded.
This air conditioner is equipped with a power supply cord having
a grounded 3 prong plug. To minimize possible shock hazard, the
cord must be plugged into a mating, grounded 3 prong outlets,
grounded in accordance with all local codes and ordinances. If a
mating outlet is not available, it is the customer's responsibility to
have a properly grounded 3 prong outlet installed by a qualified
electrical installer.
It is the customer's responsibility:
To contact a qualified electrical installer.
To assure that the electrical installation is adequate and in
conformance with National Electrical Code, ANSI/NFPA 70 -
latest edition, and all local codes and ordinances.
Copies of the standards listed may be obtained from:
National Fire Protection Association
One Batterymarch Park
Quincy, Massachusetts 02269
Power Supply Cord
NOTE: Your unit’s device may differ from the one shown.
B
A
A. Reset button
B. Test button
This room air conditioner is equipped with a power supply cord
required by UL. This power supply cord contains state-of-the-art
electronics that sense leakage current. If the cord is crushed, the
electronics detect leakage current and power will be disconnected
in a fraction of a second.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can
result in death, fire, or electrical shock.
To test your power supply cord:
1) Plug power supply cord into a grounded 3 prong outlet.
2) Press RESET (on some devices, a green light will turn on).
3) Press TEST (listen for click; Reset button will trip, and on
some devices, a green light will turn off).
4) Press and release RESET (listen for click; Reset button will
latch, and on some devices, a green light will turn on). The
power supply cord is ready for operation.
NOTES:
The Reset button must be pushed in for proper operation.
The power supply cord must be replaced if it fails to trip
when the test button is pressed or fails to reset.
Do not use the power supply cord as an off/on switch.
The power supply cord is designed as a protective
device.
A damaged power supply cord must be replaced with a
new power supply cord obtained from the product
manufacturer and must not be repaired.
The power supply cord contains no user serviceable
parts. Opening the tamper-resistant case voids all
warranty and performance claims.
INSTALLATION INSTRUCTIONS
Do not use sharp instruments, rubbing alcohol, flammable
Unpack the Air Conditioner
WARNING
Excessive Weight Hazard
Use two or more people to move and install air
conditioner.
Failure to do so can result in back or other injury.
Remove packaging materials
Remove and properly dispose of packaging materials.
Remove tape and glue residue from surfaces before turning on.
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your air conditioner.
Handle air conditioner with care.
Prepare Air Conditioner for Installation
1. Locate provided bags of screws.
2. Place the top channel on top of the air conditioner, lining up
the holes in top channel with the holes on top of air
conditioner.
3. Using 2 - #8 x 3/8" pan-head screws, attach top channel to air
conditioner.
5