Filter
Top Products
5
ASSEMBLY
Remove the heater body and base from the
box. Remove the packaging materials and
keep for future storage.
Slide the neck of the heater head into the
column connected by the cord, so that the
holes in the neck align with the holes in the col-
umn.
Insert and tighten the screws with a Philips
screwdriver.
Slide the cord through the opening in the back
of the base.
Insert the lip near the control panel into the
opening in the front of the base. Push the body
and base together. The tip-over safety switch
should protrude out the bottom of the base.
Attach the base to the heater body by screwing
on the fastening screw.