Filter
Top Products
8
Operation
PLEASE READ ALL INSTRUCTIONS BEFORE OPERATING HEATER!
1. Make sure the Temperature
Control Knob is at the “DOT”
position. [Fig 1]
Make sure the power switch is at
the off position.
[Fig 2]
2. Plug the power cord into a
suitable electrical outlet.
[Rated not less than 115 volt].
3. Turn the power switch to the
“ON” position. Adjust the
Temperature Control Knob
clockwise until the Red Light
Indicator turns on [Fig 2]. The
Temperature Control should
begin.
Note: The Red Light Indicator
will turn off when the room
reaches the desired temperature.
After a while, as the room
temperature falls, the heater will
turn on again and release heat
until the room temperature rises
to the desired temperature.
Desired room temperature is
maintained automatically by this
procedure.
You can adjust the temperature
control knob to increase or
decrease the room temperature as
desired by turning the knob
clockwise or counter-clockwise
direction as shown in Fig 2.