Soleus Air GM-WAC-10ESE-C Air Conditioner User Manual


 
If AC is Blocked by Storm
Window
Add wood as shown in FIG. 14, or remove storm
window before air conditioner is installed.
SASH
STORM WINDOW
FRAME
OR OTHER
OBSTRUCTION
BOARD
THICKNESS
AS REQUIRED,
FOR PROPER
PITCH TO
REAR, ALONG
ENTIRE SILL.
FASTEN WITH
NAILS OR
SCREWS.
FIG. 14
If Storm Window Frame must remain, be sure the
drain holes or slots are not caulked or painted
shut.Accumulated Rain Water or Condensation
must be allowed to drain out.
Removing AC From
Window
*
Turn AC off, and disconnect power cord.
*
Remove sash seal from between windows,
and unscrew safety lock.
*
Remove screws installed through frame and
frame lock.
*
Close (slide) side panels into frame.
*
Keeping a firm grip on air conditioner, raise
sash and carefully “rock” air conditioner
backward to drain any condensate water in
base of unit. Be careful not to spill any
remaining water while lifting unit from
window. Store parts WITH air conditioner.
AIR CONDITIONER USE
Operating your air conditioner properly helps you to obtain the
best possible results.
This section explains proper air conditioner operation.
IMPORTANT:
If you turn off the air conditioner, wait at least 3 minutes
before turning it back on. This prevents the air conditioner
from blowing a fuse or tripping a circuit breaker.
Do not try to operate your air conditioner in the cooling
mode when outside temperature is below 65°F (18°C).
The inside evaporator coil will freeze up, and the air
conditioner will operate properly.
NOTE:
In the event of a power failure, your air conditioner will
operate at the previous settings when the power is restored.
9