Filter
Top Products
CONTROL PABEL & DISPLAY
When pressing key is valid, buzzer makes a sound, indicate dlamp indicates relevant state, syste mwill last for
2 seconds.
OPERATING INSTRUCTIONS
l.
3.MODE Button
4. Fan speed
When the unit is running in Cool or Fan mode,press the Fan speed Button to select the fan speed
in High,
Middle, Low , Auto.
In cool mode, it can decrease the temperature of the room, and make people very
comfortable.
ON/OFF Button
2. "+","-"
Button
In COOL mode, press "-" once, the set temperature will decrease 1
, press "+" once, the set
temperature will
C
(
F
)
Receiver window
LED window
DRY mode lamp
Temperature selection button
COOL mode lamp
MODE buttonFAN mode lampFAN Speed lamp ON/OFF button
Fan speed button
Button
CONTROL PANEL DISPLAY & OPERATING INSTRUCTIONS
6. Louver Direction
This unit has 4-Way directional louvers.
Use the louver guides to direct air where
cooling or fanning is needed most.Hold the
louver and adjust the air flow direction,
as show in the right diagram.
5.Water Full
When COOL or DRY is running, condensate will drain to
water tank. When water tank is filled. buzzer will sound 8
times, LED screen show error code ‘H8’.
In this case, reference page 8 to drain out water intank.
Press the button once to manually turn the unit on. Press once more to turn the unit off.
Press MODE Button repeatedly to cycle between the modes:Cooling,Dry,and Fan only mode.
Each press of
the MODE
button will light up a different lamp on the control panel. The exhause
hose and window kit must
be installed when the
unit is in Co
olor Dry mode.When using the unit
as a fan,it is unnecessary to keep the
exhaus
t hose and window kit
connected to the unit.
Hold this hand grip to adjust the
direction of Horizontal Louvers
Hold this hand grip to adjust the
direction of Vertical Louvers
incresae 1C ( F).The set temperature rang from 16 Cto 30 C(61 F to 86 F)
10