Filter
Top Products
ASSEMBLY INSTRUCTIONS
Tools required: Phillips screwdriver (not included)
1) Remove the fan and packaging materials from the box.
Base Assembly
1) Attach the Lower Pole (M) to the Fan Base (N) with the included Screws (P) and
Washers (O).
2) Attach the Upper Pole (I) to the Lower Pole (M) and tighten the screw located on
the bottom of the Upper Pole (I).
Fan Head Assembly
1) Unscrew (turn clockwise) the Fan Blade Cap (C) if it attached to the Motor Shaft
(G). Note: Fan Blade Cap (C) may be included in a plastic bag and not attached to
the Motor Shaft (G).
2) Unscrew (turn counter-clockwise) the Mounting Nut (E) from the Motor Shaft (G).
3) Position the Rear Grill (F) over the Motor Shaft (G), fitting the holes in the Rear
Grill (F) over the knobs that protrude from the motor. Make sure the grill fits
securely against the motor housing.
4) Screw-on (turn clockwise) the Mounting Nut (E) to secure the Rear Grill (F) to the
Motor Housing (H).
5) Attach the Fan Blade (D) to the Motor Shaft (G) by aligning the slots on the Fan
Blade (D) with the bars on each side of the Motor Shaft (G).
6) Secure the Fan Blade (D) onto the Motor Shaft (G) by turning the Fan Blade Cap
(C) counter-clockwise.
7) Align the Front Grill (A) with the Rear Grill (F).
8) Place the Grill Ring (B) on the outer most edge of the Grill and secure using a
Phillips head screwdriver.
6