Filter
Top Products
PREPARATION FOR USE
1. Remove the front panel by
pressing the two small buttons
on the bottom of each side.
2. Remove the Dust Frame
3. Remove the HEPA & Cold
Catalyst Filter Holder
4. Remove the HEPA & Cold
Catalyst Filter from the package.
5. Insert HEPA & Cold Catalyst
Filter into the holder.
6. Place the HEPA & Cold Catalyst
Filter Holder back into the unit.
7. Place the Dust Frame back into
the unit.
8. Close the Front Panel
9. Remote
- Remove the battery
holder in the Remote Control
10.Place the battery inside the
holder. Make sure to align the
battery according to the image
to the right.
5
1
2
3
4 & 5