Filter
Top Products
REMOTE CONTROL
A. Temperature/Timer Adjustment Buttons
B. Cooling Mode
C. Dehumidifying Mode
D. Fanning Mode
E. Heating Mode
F. On/Off Button
G. Timer Button
H. °C/°F Converting Button
I. Airflow Button
J. Fan Speed Buttons
WATER DRAINAGE
When the unit is in cooling mode, unwanted water is extracted from the air. Most of this water is used to cool the unit and make
it run more efficiently. When the unit is used in extremely humid environments, water will collect in a water container at the
bottom of the unit. When the water container is full, the compressor will stop but the fan will continue to run.
When the water container is full, the unit will display E7 on the control panel until the tank is emptied. To resume operation,
empty the water container according to the following steps:
1. Turn the unit off. Do not move the unit when the water container is full.
2. Place a 2L pan (or the drain pan) under the drainage port at the back of the unit.
3. Remove the rubber plug from the drainage port. The condensate water will drain out automatically. When the 2L pan
(or the drain pan) is full, put the rubber plug back to the drainage port to stop the water. Empty the drain pan.
Repeat until all the water is emptied.
4. Once the water container has been emptied, replace the rubber plug into the drain hole firmly. Do not allow the water
to drip continuously into the drain pan, as it might easily overflow.
10