Snapper 2730 Vacuum Cleaner User Manual


  Open as PDF
of 2
 
4. In the top hole (B, figure 2) of the mower deck, install
the 3/8-16
x
7/8 carriage bolt
(.I,
figure 1) and l/Z”
washer (I) from bottom. Secure with
318
locknut(H)
on top of deck.
5. Raise the mower
deflectori+,install the.;adapier.
6. Hook the adaptor hold-down (R, figure 1) onto the
stone guard (C, figure 2). Then, lift the adaptor up into
place, hooking onto the spacer (D, figure 1). The
spring latch (K) should snap over the carriage bolt(J)
installed on mower deck in step 4.
AWARNING
Shut off the engine and
mmve
key before
removing my part of the
YBCUU~
collector.
REMOVAL
To operate without the vacuum collector, remove the
adapter as follows. Unhook spring latch from bolt in
mower housing and then pull off, unhooking from spacer
and stone guard. Be sure mower deflector is down in
original position.
 previous