Filter
Top Products
17
Instructions for the installer
2. INSTALLING THE PARTS
2.1 Installing the tap
Prepare the area where the tap is to be installed then proceed as
follows:
• Insert the tap (2) into the housing hole (1), making sure that the o-
ring seal (4) is in place between the tap and the sink contact
surface.
• Underneath the sink, insert the plastic below-sink reinforcement (5),
together with the rubber seal (6).
• Fix the tap in place by inserting the mounting flange (7) and the
hold-down nut (8); check that the tap is in the correct position in
relation to the sink and tighten the nut using a suitable spanner or
similar tool.
2
4
1
6
5
7
8