Filter
Top Products
B. BEFORE OPERATING smell all around the appli-
ance area for gas. Be sure to smell next to the floor
because some gas is heavier than air and will settle
on the floor.
WHAT TO DO IF YOU SMELL GAS
• DO NOT try to light any appliance.
• DO NOT touch any electric switch; DO NOT use
a
ny phone in your building.
• Immediately call your gas supplier from a neigh-
bor’s phone. Follow the gas supplier’s instructions.
• If you cannot reach your gas supplier, call the fire
department.
C. Use only your hand to push in or turn the gas control
knob. NEVER use tools. If the knob will not push in
or turn by hand, DON’T try to repair it, call a quali-
fied service technician. Force or attempted repair
may result in a fire or explosion.
D. DO NOT use this appliance if any part has been
underwater. Immediately call a qualified service
technician to inspect the appliance and to replace
any part of the control system and any gas control
which has been underwater.
LIGHTING INSTRUCTIONS
1. STOP! Read the safety information on page 7 and
above.
2. Set the thermostat to lowest setting.
3. Turn off all electrical power to the appliance.
4. Remove control access panel. (Galaxy models
only.)
5. Turn gas control knob clockwise to “OFF”.
6. Wait five (5) minutes (longer for propane) to clear
out any gas, then smell for gas, including near the
floor. If you then smell gas
STOP! Follow “B” in the
safety information above on this page, if you don’t
smell gas, go to next step.
7. Remove the pilot access panel located below and
behind the gas control unit.
8. Find pilot, follow metal tube from
gas control. The pilot is between
two burner tubes behind the pilot
access panel.
9. Turn knob on gas control counterclockwise
to “PILOT”.
10. Push in red button all the way and hold in.
Immediately light the pilot with a match. Continue to
hold the red button in for about one (1) minute after
the pilot is lit. Release button and it will pop back
up. Pilot should remain lit. If it goes out, repeat
steps 5 through 10.
• If button does not pop up when released, stop
and immediately call your service technician or
gas supplier.
• If the pilot will not stay lit after several tries, turn
the gas control knob to “OFF” and call your
service technician or gas supplier.
11. Replace pilot access panel.
12. Turn gas control knob counterclockwise to
“ON”.
13. Replace control access panel. (Galaxy models
only.)
14. Turn on all electric power to the appliance.
15. Set thermostat to desired setting.
TO TURN OFF GAS TO APPLIANCE
1. Set the thermostat to lowest setting.
2. Turn off all electric power to the appliance, if service
is to be performed.
3. Remove control access panel. (Galaxy models
only.)
4. Turn gas control knob clockwise to “OFF”. DO
NOT force.
5. Replace control access panel. (Galaxy models
only
.)
These boilers are equipped with both a blocked vent
saf
ety switch and a rollout safety s
witch. The blocked
vent safety switch is located on the draft hood flue stack.
This is a manual reset control used to prevent excessive
spillage of flue gases from the draft hood. The rollout
safety switch is a single use (one time) thermal fuse to
prevent the boiler from operation if flue passages are
b
locked. If either of these devices operate to shut down
the burners, follow instructions in the section “To Turn
Off Gas To Appliance” and call your service technician
or gas supplier.
Your gas boiler must be installed and serviced by a qualified service agency or
gas supplier. The lack of proper service can result in a dangerous condition.
SLANT/FIN CORPORATION, Greenvale, N.Y. 11548 • Phone: (516) 484-2600
FAX: (516) 484-5921 • Canada: Slant/Fin LTD/LTEE, Mississauga, Ontario
www.slantfin.com
©Slant/Fin Corp. 2004.