Filter
Top Products
4
1. Screwdriver
2. 1,5 mm Allen wrench
3. Needles
4. Cleaning brush
5. Machine cover
6. Instruction book
Setting Up
Attaching the power cord and
foot control
Plug the power cord into machine socket,
then into a wall outlet. Always make sure the
power is OFF and remove the plug from the
wall outlet when the machine is not in use,
or when making any adjustments such as
changing needles or light bulb.
Note: Before plugging in, check to ensure that
the foot control is of type “4C-337G” or
“C-9000”.
Machine speed
The machine speed is adjusted by increasing
or decreasing the pressure on the foot
control.
When not in use, do not place anything on
the foot control to prevent damage to the
foot control or motor.
For the USA and Canada
This sewing machine has a polarized
plug (one blade wider than the other).
To reduce the risk of electric shock,
this plug is intended to t in a polarized
outlet only one way. If the plug does not
t fully in the outlet, reverse the plug.
If it still does not t, contact a quali ed
electrician to install the proper outlet.
Do not modify the plug in any way.
Accessories
5
English
Cloth Presser
The cloth presser is to prevent cloth/fabric/
materials from lifting during the felting
process.
1. Place the cloth/fabric/materials on the
needle plate and under the cloth presser.
2. Loosen the cloth presser height adjusting
screw to adjust the height of the cloth
presser.
3. Move the clear fabric cover with needle
guard up or down until the red indicator
on the presser bar aligns with the correct
height for the thickness of your fabric
and felting material.
L= low position for thin or medium fabrics.
M= medium position for medium weight
fabrics.
H= high position for heavy or thick fabrics.
4. Tighten the clear fabric cover height
adjusting screw.
Note: The fabric and felting material must move
freely under the clear fabric cover with needle guard
without any restrictions.
34074 Singer ER10 Manual.indd 5 6/30/08 10:00:33 AM