Filter
Top Products
12
ENGLISH
sTarTInG Cold enGIne
1. Stop Switch
Move stop switch button (A) away from the STOP position.
2. Throttle Position Lever
Move throttle position lever (B) midway between idle and full
throttle positions.
3. Choke
Move choke (C) to Cold Start ( ) Position.
4. Purge Bulb
Pump purge bulb (D) until fuel is visible and ows freely in the
clear fuel tank return line. Pump bulb an additional 4 or 5 times.
IMPORTANT
Recoil starter: Use short pulls - only 45 ~ 60 cm (18 ~ 24 in.) of
rope for starting. Do not allow the rope to snap back in. Always
hold the unit rmly.
5. Recoil Starter
Place the unit on a at, clear area. Firmly grasp throttle grip with
left hand and rapidly pull recoil starter handle/rope (E) until
engine res (5 pulls maximum).
6. Choke
After engine res (or 5 pulls), move choke lever (C) to “Run”
( ) position, then pull starter handle/rope until engine starts
and runs. Allow unit to warm up at idle for several minutes.
NOTE
If engine does not start with choke in “Run” position after 5 pulls,
repeat instructions.
7. After engine warm up, gradually depress throttle trigger to in-
crease engine RPM to operating speed.
A
B
C
D
E