Filter
Top Products
5. Indicator Lights – Indicator lights tell the user when the unit
is on, (“Power” symbol), and when the unit's mode is set to
have ions emitted, (“Ions” symbol).
6. Filter Condition Monitor – When the ball, at high speed
setting, reaches the high end of the indicator scale, the filter
cartridge is loaded with particulate pollutants and needs
changing (LC0760 & LC1060).
7. Fan Control – The air-cleaning rate of the unit can be
controlled for maximum efficiency and convenience. The
two speed fan control is used to select the operating speed
of the fan. The unit is designed to run continuously at the
low speed setting. For extended motor life, it is recommend-
ed that the high speed setting be used only when necessary.
8. Filter Check Light (LC1460) – An electric switch senses the
condition of the filter cartridge and turns on an indicator light
if the filter cartridge needs to be changed.
PRE-OPERATING INSTRUCTIONS
1. When removing the unit from the packing case, visually
check for shipping damage. Please contact both the shipper
and your dealer immediately if the unit bears any sign of
damage from mishandling. All Bionaire
®
units are carefully
inspected before leaving our factory.
2. KEEP SHIPPING CARTON AND PACKING for use in the
unlikely event that your Bionaire
®
unit needs servicing. If this
unit is shipped without the original packing, damage could
occur and void the warranty.
3. PLEASE REFER TO THE FOLLOWING PROCEDURE
BEFORE OPERATING YOUR NEW Bionaire
®
Air Cleaner.
WARNING: Check the operating voltage shown on
the back of the unit. Do not operate at voltages other
than shown.
OPERATING INSTRUCTIONS
1. Remove the inlet grill, remove the HEPA filter cartridge and
the carbon filter and remove any plastic wrapping or panels
from them. Re-install the filters as per the section “Filter
Replacement”.
2. After re-installing the filters, choose a suitable location,
table top, shelf or wall (see wall-mount instructions)
ensuring that both the air intake and exit are not obstructed.
The air cleaner can be placed as a vertical “tall” unit, or
5