Filter
Top Products
E-8
SPECIFICATIONS
TROUBLESHOOTING
*The target oor surface area, for which an emitted airborne ion density
is of about 25,000 ions/cm
3
,
can be measured at a point near the center of the room (at a height of about 1.2 m from the oor),
during operation at the HIGH mode when the main unit is placed near a wall.
• The number of ions will vary according to the room conditions and the the main unit operation mode.
Model
Power supply
Power consumption
(W)
Operating noise level (dBA)
Airow volume(m
3
/hour)
Applicable oor surface area (m
2
)*
Power cord (m)
Outer dimensions (mm)
Weight (kg)
220-240V, 50/60Hz
(High)
14.0
(High) 44
(High) 102
10
1.8
140 160 345 (W D H)
2.5
IG-A10EK
(Low) 6.5
(Low) 34
(Low) 72
Before calling for service, please review the TROUBLESHOOTING chart below, since the problem
may not be a Plasmacluster Ion Generator malfunction.
Problem
WHAT TO DO
The Plasmacluster Ion Generator
does not work.
Make sure the unit is plugged in.
Approx. 2 years and 2 months (approx. 19,000
hours) has been passed.
Replace with a new Plasmacluster Ion
Generating Unit. See page E-6,7.
Plasmacluster Ions are not released.
Press the Operation button and restart.
Failure
Unplug and contact the store you purchased or
Sharp Service Center.
The discharged air has odor. The Plasmacluster Ion Generator releases a
small trace of ozone which may produce odor.
This is not harmful to health.
A clicking or ticking sound comes
from the unit while operating the
Plasmacluster Ion Generator.
Loudness can be changed depending on a room
humidity, but the effectiveness is the same.
Relocate the Plasmacluster Ion Generator if
necessary.
ashing faster
(red)
ashing (red)
ashing (blue)
ashing (blue)
ashing (blue)
If all lights keep ashing, replace with new
Plasmacluster Ion Generating Unit. See page E-6,7.
•
Dust may block the lter, clean the lter.
IG-A10EK.Jpn_Eng.indd 20 09.10.9 10:03:36 AM