Filter
Top Products
ENGLISH
FRANÇAIS
E-17
TROUBLESHOOTING
Before calling for repair, please review the list below, since the problem may not be a unit malfunction.
SYMPTOM
REMEDY (not a malfunction)
The Remote Control does not
work
• Have the batteries been depleted?
• Are the batteries inserted correctly?
• Is a fluorescent lighting in the room flickering due to service
life?
Odors and smoke are not re-
moved
• Clean or Replace the filters if they appear to be heavily soiled.
(Refer to E-15)
The CLEAN-SIGN Light lights
green even when the air is im-
pure
• The air could be impure at the time the unit was plugged in.
(Refer to E-13)
The CLEAN-SIGN Light lights
orange or red even when the air
is clean
• The sensitivity of the sensor becomes unstable when the
opening of the odor sensor is dirty or is clogged.
Clean the dust around the sensor opening using a vacuum
cleaner. (Refer to E-15)
• When in Clean Mode ( or Ion Control Mode), the Plasmacluster
Indicator Light color will not change.
A clicking or ticking sound is
heard from the unit
• Clicking sound is emitted when the unit is in the Ion Control
Mode, and ticking sound is emitted when the unit is generating
ions.
If the sound is irritating, set the unit away from you.
The discharged air has an
aroma or odor.
• Check to see if the filters are heavily soiled.
Replace the filters.(Refer to E-16)
• Plasmacluster Air Purifiers emit small traces of ozone which
may produce an odor. These ozone emissions are well below
safety levels set by the FDA.
The Plasmacluster Indicator
Light remains green (or blue)
and does not change
The unit does not operate when
cigarette smoke is in the air.
• Is the unit installed in a location that is difficult for the sensor to
detect cigarette smoke?
• Are the odor sensor openings blocked or clogged?
(In this case, clean the openings.) (Refer to E-15)
The Plasmacluster Indicator
Light or the CLEAN-SIGN Light
will not activate.
• Check to see if the Lights OFF Mode on the Remote Control is
selected. If so, then press the Lights ON/OFF Button on the
Remote Control to activate the Lights light.
(Refer to E-14)
ERROR DISPLAY
LAMP INDICATION
REMEDY
The “Silent” Fan Speed Indica-
tor Light blinks.
Fan motor disconnected or abnormal.
Operation stops.
• Pressing the Power ON/OFF button will reset the error display,
but if error occurs again, contact the shop where you purchased
the unit.