Filter
Top Products
Flat & Upright Parking Position
Please note that your vacuum cleaner
can be conveniently placed in a space
saving vertical parking position or in a
flat parking position.
1. For vertical parking, place the main
unit in the upright position as shown
in Fig. 22.
2. For horizontal parking position,
place the vacuum flat on its 3
wheels and slide the floor brush into
locking position with the receptacle
which rests on the rear of the unit.
(Fig. 23 & 24)
Fig. 23
Fig. 24
OPERATING INSTRUCTIONS
Replacing the Post Motor Filter
The white polyfoam post-motor filter is
located at the rear of the main unit.
1. Press down on the post-motor filter
door release button and remove the
post-motor filter door. (Fig. 19 & 20)
2. Remove the filter. (Fig. 21)
Post-Motor Filter Door
Release Button
Fig. 21
8
Fig. 22
Receptacle
Fig. 20
Motor Thermostat
Important: This unit is equipped with a
motor protective thermostat. If for some
reason the vacuum cleaner should
overheat, the thermostat will
automatically turn the unit off. Should
this occur:
• Push the On/Off button once.
Disconnect the plug from the power
source.
• Check the source of overheating
problem. (i.e. clogged hose or filter)
• If clogged hose or filter is found,
unclog the hose and replace the
filters.
• Wait at least 45 minutes before
attempting to reuse the vacuum.
• After unit has cooled down for 45
minutes, plug in the cleaner and push
the On/Off button. The vacuum
should start again.
• If the vacuum still does not start,
contact customer service at
1(800) 798-7398.
Fig. 19
3. Wash the filter and allow it to air dry it
for 24 hours. Then re-insert the filter
and close the post-motor filter door.
1
2
3
4
5
6
7
8
9
10
11
13
12
14
15
16
17
APPRENEZ À CONNAÎTRE VOTRE ASPIRATEUR
LÉGER À TRAINEAU
23
Spécifications Techniques
Voltage: 120V. 60Hz.
Puissance: 10 Ampères
1. Tuyau flexible
2. Brosse à épousseter
3. Suceur plat
4. Brosse turbo entraînée par
air
5. Bouton de dégagement du
tuyau
6. Sac à poussière
7. Lumière indicatrice du sac à
poussière
8. Bouton de rembobinage de
cordon
9. Poignée de transport
10. Bouton marche/arrêt
11. Brosse à plancher et tapis
12. Unité principale
13. Tuyau d’extension inférieur
14. Chariot d’accessoires
15. Tuyau d’extension supérieur
16. Tube courbé/Extension du
tuyau
17. Contrôle manuel de la succion
Les illustrations peuvent différer du produit exact.
Fig. 18
Cleaning the Pre-Motor Filter
The white polyfoam pre-motor filter is
located inside the main unit, behind the
dust bag.
1. Open the vacuum cover and pull the
filter straight up and out of the
vacuum.
2. Wash the filter and allow to air dry
for 24 hours.
3. Slide a clean filter into position
between the two posts and the
motor intake. (Fig. 18)