Sharp CV -P09FX Air Conditioner User Manual


 
ENGLISH
E-27
1
ON TIMER
Display shown when you set
the unit to turn on 6.5 hours
later.
The unit will turn on automatically according to your setting.
Timer duration can be set from a minimum of half an hour (30 minutes) to a
maximum of 12 hours.
Up to 9.5 hours, you can set in half-hour (30-minute) increments and from 10 to 12
hours, in 1-hour increments.
Point the remote control at the signal receiver win-
dow on the unit.
1
Press the ON TIMER button.
The time setting will change as you press the button
as follows.
Hold the button down to speed through the set-
tings.
The orange TIMER lamp on the unit will light.
The unit will emit a beep when it receives the signal.
The time setting will count down to show the re-
maining time.
TO CANCEL TIMER
Press the CANCEL button.
The orange TIMER lamp on the unit will turn off.
Select the mode, temperature, fan speed setting
and PLASMACLUSTER operation as desired.
When the temperature is set with the ON TIMER,
the temperature will show in the display for 5 sec-
onds and then return to the time display.
If you do not change the setting, the unit will operate
using the most recent setting.
0.5h 1.0h 1.5h 10h 11h 12h