Filter
Top Products
GB-13
ENGLISH
BEFORE CALLING FOR SERVICE
The following conditions do not denote equip-
ment malfunctions
Unit does not operate
• The unit will not operate if it is turned on im-
mediately after it is turned off. The unit will not
operate immediately after the mode is changed.
This is to protect the unit. Wait 3 minutes before
operating the unit.
Unit does not send out warm air
• In heating operation, the indoor fan may not
start for 2 to 5 minutes after the unit is turned on
to prevent cold air from blowing out of the unit.
• The unit is defrosting. Wait for 3 to 12 minutes.
During defrosting, the red TURBO FAN lamp
(
) on the unit ashes.
Odors
•
Carpet and furniture odors that entered into the
unit may be sent out from the unit.
Cracking noise
• This sound is generated by the friction of the
unit expanding or connecting due to a tempera-
ture change.
A low buzzing noise
• This is a sound of the unit generating Plasma-
cluster ions.
Swishing noise
• The soft, swishing noise is the sound of the re-
frigerant owing inside the unit.
Mist seen at indoor air outlet
• In cooling operation, this is caused by the differ-
ence between the room air temperature and the
air discharged.
Water vapour
• In heating operation, water vapour may ow out
of the outdoor unit during defrosting.
The outdoor unit does not stop
• After stopping the operation, the outdoor unit
will rotate its fan for about a minute to cool down
the unit.
Odor emitted from the plasmacluster air
outlet
• This is the smell of ozone generated from the
Plasmacluster Ion generator. The ozone con-
centration is very small, posing no adverse ef-
fect on your health. The ozone discharged into
the air rapidly decomposes, and its density in
the room will not increase.
Check the following points before calling for
service.
The unit does not operate
• Check if the circuit breaker has tripped or the
fuse has blown.
The unit does not cool(or heat) the room ef-
fectively
• Check the lters. If dirty, clean them.
• Check the outdoor unit to make sure nothing is
blocking the air inlet or outlet.
• Check the temperature setting is proper setting.
• Make sure windows and doors are closed tight-
ly.
The unit does not receive the remote control
signal
• Check whether the remote control batteries
have become old and weak.
• Try to send the signal again with the remote
control pointed properly towards the unit’s sig-
nal receiver window.
• Check whether the remote control batteries are
installed properly.
01_AYXP9_12RMR_OM_EN.indd 13 14/08/29 16:48